Posted by ScottyHOMEy on November 01, 2009 at 09:42:41 from (71.241.205.174):
In Reply to: Re: C magneto posted by jim from az on November 01, 2009 at 09:19:58:
A bungled jump start (12/6, reversed polarity . . .) shouldn't be a factor with your problem. The mag is an isolated unit, totally independent of the rest of the tractor's electrical system.
It could be a weak magnet, but it's more likely your problem is going to be coil or condenser. Either one will require removing the mag, so all the precautions of having the motor set up at TDC on compression on #1 before removal (and then not disturbing it) will make the job less prone to problems when poutting things back together. Both the coil and the condenser will require removing the rectangular cover on top and the cover on the motor side of the mag. Handle the two insulators for the stud on the condeser carefully (the little brown ones, one inside, the other visible on the outside around the connection for the ground wire), they're not easy to come by.
Before getting into that , please do try shining up the points, they'll look good but a little corrosion on them will keep yo from running.
One other pesky little thing that pops up now and then, too, is a short from the wire between the consenser and the points where it passes though the distributor body. That's be worth a look.
Worse comes to worse, you can have it rebuilt or swap it as a core for one already rebuilt. If it comes to that, I've heard good things about the shop at the link below. Theres' also Magman, but his link isn't working. Maybe someone else will have a way to contact him.
Good luck and come back for more if we can help. Theres' better hands with mags than me around here.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
