Tractor Talk Discussion Board |
Re: Hydraulic filter in pressure line.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on January 21, 2001 at 16:54:50 from (207.254.53.115):
In Reply to: Hydraulic filter in pressure line. posted by Bus Driver on January 21, 2001 at 11:16:27:
Hi BD, You can put a filter in the high pressure line but there more expensive as they now have to be pressure rated. Filters are installed in the suction side of the pump and have a internal bypass valve incase they plug up thus they can never cavitate the pump. A suction screen can plug but some do have bypass valve. Filters are flow rated so they have to be sized to the system. As one of the posters pointed out, most tractors the filter is in the reservoir on the pump intake. If yours doesn't have one be sure and check the parts manual as alot of tractor owners removed them and didn't install a new filter. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|