paul said: (quoted from post at 22:33:54 11/06/09) How do you fill a 250 or 350 wagon with a NI 2 row pull type? I gotta take the fronts off my 220bu Parker wagons and turn them into 180bu wagons, and then it won't fill the back of the wagon so I'm lucky to be hauling 150 bu.....
I guess you guys have an elevator extention????
--->Paul
Elevator extension and high speed elevator drive. I pick into 225 bu. wagons, one Huskee, one M&W with extensions, can fill them both heaping full, starting back to front, with the top elevator corn deflector flap clear up. Pick 20-25 loads in a good picking, ten hour day, no problems or break downs, and a short haul to the pile. Far short of 350 bu. in ten minutes. My picker has been shedded since new, and the corn forwarding fingers over the twelve roll bed are all still there, and in good shape. Funny thing to me is, in my experience, the tougher the trash, the cleaner the corn picks, most ears snap right off with no husk at all. Nice weather and dry conditions is when the corn picks dirty, with lots of husks. Tough trash, and clean picking, makes for more shelled corn in the picker, and the wagon though. Corn breeders working for easier shelling corn works against the guy wanting to pick the corn in the ear. rrlund, do you have any of the steel pegs pushed into the steel rolls in your husking bed? Doesn't take many of those to make the husking rolls quite a little more aggressive. Helps clean up tough husking corn, but will also cause alot more shelling, especially in easy shelling corn varieties. Just my experiences, and two cents.
This post was edited by MirageFlatter at 02:15:06 11/07/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
