Posted by MirageFlatter on November 12, 2009 at 19:10:19 from (12.36.202.78):
In Reply to: Thinking about next year posted by Erik Ks Farmer on November 12, 2009 at 16:07:17:
I farmed for three years in SE Nebraska, '78-'80, when I first started. Since you've been growing milo, I assume you're a dryland farmer. 26-29K would be way to thick for dryland corn, 15-18K is probably a better recommendation, on the high side. 135 #'s of N, may, or may not be enough, depending on your yield goal, residual N, etc. If you band starter, or strip till fertilizer, you can get by with way less than 50 #'s of P, as a rule. K isn't even recommended in Nebraska as a rule, as most soils have sufficient K in them for agricultural purposes. There are simply to many variables to consider when you ask a question the way you did. Very few, if any, successful farmers today make their own plans without eliminating as many variables as possible. Inputs are way to expensive to make seat of the pants decisions. And most are going to be hesitant to make recommendations to anyone else, without more information. I once farmed a piece of ground where the previous farmers standard fertilizer program had been 200 #'s of N, and 50 #'s of P along with 30 #'s of Zn broadcast, year after year after year, no soil testing. I raised very good crops the first two years I farmed the ground, with no applied fertilizer, zilch, nada. Wait till the ground dries out enough to pull soil samples, set economically realistic yield goals, and go from there. Good luck!! :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.