Just went thru that this summer. Bought a havahart trap and got a skunk the first day. Walked up to it with a tarp and covered it. There was a slight smell. Loaded it in the PU and drove down the road and the tarp started coming loose. I slowed down instead of trying to tuck the tarp underneath.
The trick is trying to open the latch and block it open with a board to let the skunk out without being sprayed. You better figure out how to open it and run before you catch one. YOu need one hand on the latch and one hand on the lever. Than a block of wood or some wire to hold the door open. The skunk ambled out on his own without spraying. When I trapped a oppossum, it dug its claws into the wire and wouldn't come out even when I stood it up. Finally poked it out with a stick. Guess I'll try it upside down the next time.
After that I got a black trash bag and it fit all round the trap and tied off at the opening. Made it look like a dark tunnel with dry cat food in it. Wrapped in a black garbage bag will help avoid using the tarp or blanket. However, it was a 100 degrees out and my wife was worried about a cat being stuck in there for a day so she made me take the trash bag off.
That skunk did dig a place under the trap where it was trying to get out. Left a lot of dirt in the cage. I suppose it would tear up the bottom of the trash bag but still easier than trying to wrap a tarp or blanket.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.