Posted by The tractor vet on November 21, 2009 at 07:14:35 from (99.167.217.134):
In Reply to: Chisel Plows posted by acfarmer89. on November 21, 2009 at 03:04:05:
If you live in my back yard with the humps and bumps we have here in N. E. Buckeye then ya had best up the H P requirements a bit and drop a shank. The 190 may pull 8 but not at the speed you need to run at . and also it depends on the chisel plow . and the points that ya have on it . My 806 has all it wants with 7 set at 10 inches and that takes a 1000 lbs on the nose to keep it on the ground and run in 1st high with the stick ahead . And if it is a DMI five shank with the tiger points set to 14 inches then even a 3788 with duals and all the weight we could hang on it along with 5 turns on the screw was not enough tractor .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.