Posted by 2510Paul on November 24, 2009 at 18:31:02 from (98.125.79.125):
In Reply to: 4020 vs 1066 posted by Wendell Burton on November 24, 2009 at 06:41:56:
I have read through many of the posts here and on the JD site. Everyone wants to compare the two, it seems if they want to do head to head comparisons they should be talking 4320 and 1066.
Anyway, to answer your question; based on your comments I believe you in your situation would be disappointed with the 1066. You said the 4020 works well for what you want it to do, the 1066 may be a little big. If what you do requires manuverability and shifting stick with the 4020. If you want brute stength and don't shift much, go for the 1066. I have driven a 1066, I like the engine but I don't like the way it shifts and I hate the noisy rear end, and the tractor does not have many hours on it. Paul
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
