Tractor Talk Discussion Board |
Re: Cross Forum Post from AC board - Prep before starting
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on January 31, 2001 at 12:18:55 from (192.232.119.194):
In Reply to: Cross Forum Post from AC board - Prep before starting posted by Shep on January 31, 2001 at 08:54:18:
This has worked for me on several occasions: 1 - Drain and refill the crankcase and install a new filter. 2 - Remove the rocker box and pour half quart of so of fresh oil over the rockers and valve stems. Leave the box off for now... 3 - Remove the spark plugs. Using a pump oil can, shoot several good squirts of oil into each jug. (A long blast of WD-40 in each hole is good alternative) 4 - Install a fresh battery. 5 - With the plugs still out, crank the motor with the starter until oil pressure shows on the gage. 6 - Check for any valves sticking open - you're likely to find at least one. You can often free a stuck valve by grabbing the top of the stem with a needlenose vicegrips and gently rotating the stem back and forth. WD-40 applied to the valve guides helps. 7 - Replace the rocker box, install some new plugs, fill the radiator and dump some fresh gas in the tank. Then cross your fingers and crank 'er up. If you're lucky you'll be rewarded with a quick (and satisfying!) cloud of blue smoke, followed by a smoothly running motor. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|