Posted by jdemaris on November 28, 2009 at 10:37:57 from (67.142.130.13):
In Reply to: Pole shed questions. posted by gun guru on November 28, 2009 at 07:04:51:
One big advantage to pole-type building is often lost because the pole-holes are machine dug and sloppy.
If you dig the holes by hand or with a small auger, keep them small, and set the poles in those holes, and pack tight, they create the main vertical support for the building.
If you machine dig (like with a backhoe) big sloppy holes, then the poles do NOT give that vertical support. That then requires temp support until you get a roof trusses and braces on - otherwise it will be not be very strong, vertically.
Skirting can be done with pressure-treated 2X6's buried a bit with a parallel coarse of 2X6s above the ground. Then close by attaching pressure-treated CDX 1/2" plywood.
If the floor is dirt, you can dig down a foot, lay a plastic vapor barrier, and then put gravel over it.
Keep in mind with pressure-treated 6X6 or 4X6 main support poles - many are NOT properly treated to put in the ground. Often you have to special order them and also often - the people selling them at the lumber yard of Home Depot are clueless. Do NOT take their word for it.
The addition I built onto my house is pole-construction at the ground level, and the 2nd story is frame.
My 40'X 30' pole barn that I did myself has one open end for tractors to pull in and a special roof pitch to hold our solar panels.
Also have what you could call a four-story pole barn. Full 1st floor, full 2nd, attic-type walk-in 3rd, and a sort of cupola with a bed in it that is at 4th floor level. All 6X6 pole construction. Insulated and heated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
