Posted by bc on November 29, 2009 at 08:40:54 from (67.66.111.187):
In Reply to: Pole shed questions. posted by gun guru on November 28, 2009 at 07:04:51:
Hello Gun. My 2 cents. Build bigger and especially if you want to park in it. My pickup measures almost 20' long and wouldn't park in an 18' slot. Allowing space to walk around, 24' is the minimum. My pickup is almost 8' wide mirror to mirror. A close fit that I don't like for smaller doors. 9' door is a minimum. The big door has to be at least 2' away from the wall to allow you to open your door when you park and 3' is preferable depending upon what storage you put on the wall. Wall storage shelves above the height of an open door works well.
Use laminated posts with the bottom part as ground contact. Use bracing on the posts and don't back fill them until the girders are up and everything is square to the world. It never fails, the top needs to kick an inch or two one way and the bottom needs to kick the other way.
Drill the holes extra big. No matter how hard you try to line them up with string, etc., you can never drill them all straight. A 3 piece of 2x6 laminate post will measure over 6" at the diagonal. An 8" hole only gives less than an inch of play on the sides. Not enough to compensate for a deep hole that may be a hair off. An inch off at the bottom of a hole may be 3" at the top of the post. If nothing else, if you don't back fill your holes, you can pull the post and reshape the hole with your digger.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.