Posted by 200cs on December 01, 2009 at 11:59:42 from (38.99.215.182):
In Reply to: Chain Saws posted by just another old geezer on November 30, 2009 at 20:45:13:
Nancy Howell said: (quoted from post at 12:40:22 12/01/09) Don't know of anyplace down here that makes their own chains. All you can get is the pre-packaged stuff hanging on the wall.
Down here, chain saws are a sideline, don't have any stores that sell just chain saws, so its very hard to come up with the higher quality chains, etc.
Wish there was a place that made high quality chains. Bet they'd be cheaper than the packaged ones, cut better and last longer.
With the strong timber industry in our area, you'd think there would be a place where you could get commercial quality chains, etc. I've never seen one. Must be a closely guarded secret.
I still believe the Stihl chains are the best you can get at least in North Texas. I have run them all: Oregan, Carleton and Stihl. And the Stihl are by far the best lasting in my opinion. Another way to get good chain is to demand "Full Chisel, Non-Safety Chain" Your dealer may try and deny it if your saw is under 4.0 cubic inch but I have never had any trouble getting it but have heard stories of problems. I guess if they figure you know what it is then you will not accept the garden variety homeowner safety chain.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.