In years past, you could get by with running ONLY 3 wires out to a remote building for 120/240 volt single phase 3 wire service, that would be 2 Hots (L1 & L2) and a Neutral (a grounDED conductor), and you would (as usual) drive a ground rod(s) at the remote location. HOWEVER the modern practice is to run 4 wires out to the remote building 2 Hots (L1 & L2) a Neutral (a grounDED conductor) and the Equipment safety ground (a groundING conductor)
THE TROUBLE IS different jurisdictions may or may not have adopted different versions of the NEC SO YOU HAVE TO CONSULT YOUR LOCAL AUTHORITY versus relying on most of us here. If they say run 3 then do that but if they say run 4 then you have to do that.
Animals are so sensitive to electrical current and shocks that old bossey may refuse to drink from an automatic watering device if it has a metal case that has a voltage potential higher then mother earth shes standing on, so there are indeed certain limited exceptions when it comes to grounding in ag buildigns used to house livestock. With paralell Neutral and phase wires and Equipment Ground Conductors ran a long distance to the outbuilding the capacitor affect can cause the equipment ground to have a potential higher then earth OUCH for old Bossey lol Soooooooo the exceptions allow you a method to bring that back down to mother earth so the waterers metal frame is the same potential as earth.. I believe that was the basic theory anyway (its been a longggggggggg time)
NOTE check with your local authority, although I used to design secondary power distribution systems as an EE Ive been long retired and rusty on current NEC so NO WARRANTY this is my best recollection ONLY
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.