Posted by RN on December 03, 2009 at 16:03:44 from (96.60.79.133):
In Reply to: OT----Corn posted by RD in Mo-2n on December 03, 2009 at 11:36:46:
Current field corn planted at dense rates-26,000 to 30,000 kernels per acre usually get one good ear per stalk. Field plots for deer sometimes planted at 1/2 that rate and will sometimes get 2 fairly good ears per stalk with current hybreds- depends somewhat on fertilizer, usually food plots get very little extra. Old standards like Reeds Yellow Dent or Bloody Butcher used to be planted 14,000 to 18,000 seeds per acre and got little extra fertilizer but often lots of manure- often had a couple ears per stalk and sometimes a extra "sucker" stalk that would develope a smaller ear with full size kernals. Some people plant hard coat "Flint" corn and get 2 or more ears per stalk with light density. Some of the Amish straight run open pollinated corn will also tend to have multiple ears depending on planting density and rain during season. One thing that throws some people off is amount of water available to help fertilizer intake- a lighter density planting in Nebraska may yield better than heavy planting in dry years. A late planting or replant in Iowa or Wisconsin, Minnesota of 85 day corn to get a feed crop for cows planted at 18,000/22,000 seed/acre instead of 28,000 seeds/acre can get a fairly good ear, some times 2 and silage will feed cows through winter. Yield will be about 1/2 -2/3 heavy plant/heavy fertilizing of a 100/110 day corn but here we have wet springs and early hard frost possible, need a quicker growing variety even in normal year, 95 day about right. This year was not best planting and growing timing of rain. RN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.