Posted by MarkB_MI on December 09, 2009 at 07:18:43 from (166.217.142.53):
In Reply to: O.T.---Wood Glue posted by Jiles on December 08, 2009 at 19:22:59:
You didn't give enough information. Most wood glues will create a joint stronger than the surrounding wood. But you need to know the application to pick the appropriate glue.
The strongest, most water-resistant glue is epoxy. If you're bulding a boat or airplane, epoxy is about the only glue to consider. WEST System epoxy is the standard by which epoxy wood glues are measured.
Resorcinol is good, but it doesn't have the gap-filling capability of epoxy. I don't care for it because it stains wood red, but it's still a good choice for many applications.
The various yellow glues are good for most applications, but they lack water resistance. The higher-end PVA yellow glues like Titebond III have water resistance, but I wouldn't compare them with epoxy or resorcinol. You need to use yellow glue with biscuit joints, because the glue makes the biscuits expand. The biggest problem with yellow glues is they set very fast, which can be a problem with a complicated setup.
I don't care for the urethane glues like Gorilla Glue. They expand when they set and make a big mess that's impossible to clean up. However, one urethane adhesive I use for difficult applications is 3M 5200 Marine Sealant. It comes in a caulk tube, and can be used as a glue when you need a lot of flexibility. It is very strong.
I don't have any experience with hide glues, but I understand they're a good choice when you need a slow-setting glue.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
