Posted by scot in pa on December 09, 2009 at 13:59:38 from (68.28.230.229):
In Reply to: I need a tractor. posted by smithjr31 on December 07, 2009 at 11:45:29:
I bought a farmtrac (Long) 535 a couple years ago. Other than a few internal changes to the motor for emissions controls, it is just a Frod. When Frod quit building whatever model that was rebadged for Long, Long bought the tooling and moved it to India. 35 HP, diesel Two-stage clutch, live hyd, power steering, not a bad tractor. The mechanical drum brakes leave a little to be desired when used individually. I run a 7 ft finish mower with it, and occasionally a 3 pt fertilizer spreader, move round bales (4x4s), rake hay (must be the drawbar height, it's the only tractor that I can use to put together a good windrow with a POS New Holland-clone Deere hayrake), and it is a fun buzz-around tractor. But you can hear the 3 cylinder coming from five miles.
Long may have shut down North American operations, which were bought up by Montana (J.B.Hunt), but any of their dealers that are still in business can order parts from India.
If I knew I could have got the financing and found a good one, I probably would have went with a 300 RC or 350 ute with quick-hitch.
I don't see many N series Frods around home, but the few stories I have heard, they weren't the greatest. And they may not use much fuel, but tractors like the Farmall H and M, JD A and B, would do more work for the amount of fuel used.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
