Posted by ann Budzinski on December 12, 2009 at 14:41:58 from (216.51.135.42):
In Reply to: carburetor flooding posted by ann Budzinski on December 10, 2009 at 11:36:57:
Hey guys, thanks so much for your guidance. I took the carb to a Farmall dealer and had a long lesson on the floats, packing, etc. I learned that if you don't bend the tab down on the floats on the hinge that the floats will drop too far and the needle will fall down and prevent the floats from working. Also discovered that the packing my husband put in the air/mixture needle valve from the carb rebuilding kit was not there! Bought the correct packing and followed the tech's instructions to the letter. We put the carb on this afternoon and it took a while to start and when IT DID...LOOK OUT BABY! Thanks so much for your support guys! You're awesome!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
