Posted by dave2 on December 13, 2009 at 06:10:55 from (139.139.35.70):
In Reply to: Strength of pipe?? posted by Ultradog MN on December 13, 2009 at 05:09:32:
It would actually be doubled in a way. I would start with a 4'x6' frame w/ the axle welded across the middle and a couple 6" long(?) collars from the next size bigger slipped on the back rail.
Then, another 4'x6' frame with a crossmember in the middle set on top and welded to the two collars for a dump pivot.Piece of 3" box tubing I have laying for the tongue and then scratch my head about how to tip it (winch/pole or hyd cylinder). Don't know if I'd understand a chart if I found one :roll:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.