Thanks for all the responses! I think grounding the lights to the battery would do the trick however I am still puzzled as to how they are supposed to work in the first place. I understand the + and - 12V system and how some of the lights operate off one while the remainder run off the other in order to balance the load off the batteries. Also the ground wire from the battery to the frame is in place.
There are two wires running to each of the lights, a power and a ground (I am assuming the black wire is the ground wire as it goes to all the lights). The power and ground wires originate at the switch. However, I have no continuity between the ground wire and the frame. If I run a jumper from ground to this this ground I have power to the lights.
So, I think I lost my connection from this ground wire to the frame. Does anybody know where this ground originates?
Buickanddeere, can I get a good wiring diagram at the # listed, the one I have is pretty fuzzy with not a lot of detail.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
