One thing no one has mentioned yet that gets forgotten way to often in working with cattle. Take her temperature often. A normal temperature for a cow is around 101.5. I would suggest getting one of the little digital thermometers that TSC or the vet should carry. A cow that doesn't clean right away isn't an emergency until she develops an infection and the first sign will be an increase in temp, even before you smell anything. If she gets above 102.5, she has an infection and needs to be seen by a vet. I completely agree on using oxytocin at 10-15 cc to get her to expel the placenta. I give it morning and night for 3 shots then if she doesn't clean the vet is called. When you give her the oxytocin, after a few minutes you can give the afterbirth a gentle tug to see if it will come out. But do not pull to hard. If the placenta is still firmly attached to the little buttons, called caruncles, on the uterus you can do permanent damage by ripping the placenta loose before the buttons are ready to let go. These buttons are what the fertilized egg attaches to at the beginning of pregnancy so if a bunch of the buttons are ruined by scar tissue, it will make it more difficult for her to get pregnant later. She might have a fertilized egg but it is wasted unless it can land and get attached to a caruncle which feeds it thru the pregnancy. I have unfortunaly had to deal with retained placentas and have found the best thing, if there is afterbirth hanging out, take a piece of twine and tie it to the placenta about 10 inches below the vulva. And then leave about a foot of twine hanging and tie something onto the end of the twine. I use spare gutter chain links and put about 5-10 pounds on the twine. It isn't enough to rip the buttons but is enough to keep a gentle constant pull on the placenta and in conjunction with the oxytocin is the best way I have found to get one to clean. Just remember, if she gets a fever at all, it isn't working and the vet needs to be there as soon as possible. Just curious, where ya at in North Michigan? I am in the Sparta area.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
