Posted by glennster on December 20, 2009 at 08:57:55 from (99.90.9.153):
In Reply to: stuck posted by amstrad on December 20, 2009 at 05:14:25:
like dean said, pull the valve cover for a look see. i would also drain the oil out of the motor and take a look at it for water and or anti freeze. it will give you a hint about what you are up against. pull the spark plugs and fill the cylinders with a mixture of 50/50 automatic transmission fluid and acetone, or buy a gallon jug of pb blaster and fill with that. also, get the mix on the rocker arms and valves too to get them loose. i put a drain pan under the motor and leave the oil plug out to see when the oil starts to pass thru the rings and drip into the crankcase. at that point you can try and bump the motor over. prolly be a good idea to drop the oil pan and check the main and rod bearings too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
