Tractor Talk Discussion Board |
Re: Horse Logging,
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Vernon Holt on February 12, 2001 at 18:04:21 from (63.151.159.143):
In Reply to: Horse Logging, posted by Canadian Cowboy on February 12, 2001 at 16:21:00:
Cowboy: I think you are on to something. Logging equipment has become heavy and designed primarily for high volume clearcut operations. I would expect that such an operation as you propose would be very much in demand by small woodlot owners. Horses and mules used for logging in southern US were penned and left in the woods near the logging site. Someone living nearby was usually engaged to feed the animals. This could be a problem for you if you work part time. Trailering an animal(s) too and fro for just a few hours work would not be very efficient. I will ever remember a team of mules which I had the opportunity to observe on a logging operation in Georgia in the early 1950's. They were a matched pair. They performed their task without the benefit of reigns, or driver. They made the cycle from woods to the logging deck without benefit of a man. They would skid tree length to the deck. A worker would unhook the logs and speak to the team. They would promptly turn around and make their way back to the woods where a worker would once again hook them to another turn of logs. He would then speak to them and they would make their way back to the loading deck. If they encountered small trees or brush, they would place their heads together so as to prevent the tree from getting wedged between them. It was back and forth all day without requiring anything more than just a gently word on both ends of the skid. It is hard to imaging the number of hours required to train such a valuable team of animals. Good luck to you in your venture. You can do it! Vernon Holt
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|