Posted by JK-NY on December 23, 2009 at 07:46:36 from (4.157.26.110):
In Reply to: Tire questions posted by Zachary Hoyt on December 22, 2009 at 13:46:17:
I have put new rear tires on 3 of my tractors here as well as taken a couple apart to fix tire and /or rim , as well as many car,truck,implement and wagon tires, all by hand. I always take the rim off the tractor to break the bead - never had any luck getting them broke with rim on the tractor.I use a handyman jack under drawbar or truck bumper to break beads, tire irons to bar the tires off/on as well as a small sledgehammer.Dish soap/water or tire lube to lube bead helps - I sometimes use a little grease sparingly on tires going on real rusty rims - it slows down the tire from rusting back on as bad and have never had a problem although many people frown on this practice. Other ways to break beads are a large slide hammer with proper end on it or tire hammer - special sledge hammer. I have changed many large truck tires over the years with the tire hammer - you dont want to hit the rim with one. I have found the handyman jack works better on rusted on tire beads. The other replies covered most of it. Are your current tires loaded - then you have to drain them first - save fluid for the new ones. The only other advice I have which isnt already mentioned - tires are alot easier to work with when warm - so if you dont have a warm shop to work in, you may find it better to wait till spring unless you have aflat or damaged tire that wont make it till then. I agree with the others - you may find a deal on used tires if you keep looking- craigs list and swap sheet are good places to look in Central NY.You may also want to call a farm tire dealer - they may have decent used tires they took off - some times if a person has a rear tire go bad they replace both and the tire man has a good used tire.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
