Posted by The tractor vet on December 31, 2009 at 19:54:12 from (99.167.217.134):
In Reply to: Re: tire ballest again posted by Wilamayb on December 31, 2009 at 18:15:27:
Do you have any idea on how may wheel weights it takes to equal the weight of Cal. loaded tire ?? and do you know how far out they will be past the tire . And i do not know where you get you info but it sure ain't all true . I happen to live with in 14 miles of the Firestone Ag tire test center and have been there and seen testing of farm tires with and with out fluid and with weights and ya can not hang enough iron to get the same traction as fluid . we have tractors with and WITH OUT fluid in the tires and the rough ride thing is BULL SHUT as we do a LOT of road travel with all the tractors , the onlything that you will see is tire ware with loaded tires moreso then no weight , BUT you will see the same ware if ya had the iron on them. Now to equal the weight of a loaded 18.4X34 you would have to hang 10 150 wheel weights on each side and think of how far out they would stick past the tire . And even with loaded tires there are times that we still have to add four sets of Donuts for a bit of extra weight. Yes if they leak it will rust the rim BUT it will not eat it out in a couple days or a couple years . Your SUPPOSE TO FIX a leaky tire . Yes it costs a few bucks to get one fixed and i am CHEEP but i do not get my rocks off fixen tires i can do it but why should i when i can get someone else to come and pump it out break it down patch the tire and tube and refill it for a buck and a half ($150) while i do something that makes money . It is only money , ya can't eat it ya can sleep with it and is only a way of keeping score .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.