|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Alternator Update
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on February 25, 2001 at 21:37:35 from (63.160.194.150):
In Reply to: Re: Re: Re: Alternator Update posted by Bob M on February 25, 2001 at 19:20:05:
Bill, If I understand right that you are using the stock ign/light switch for ignition then it will work to connect the alt #1 wire to the light terminal on the switch with no light or diode, but you will have to turn the switch past the ign position to the light position. If you want to connect the alt#1 wire to the ign terminal of the switch,so you need only switch to the ign position then Bob M's advice about a alt light or diode is dead on. amd as he says attach the #2 wire to the bat terminal on the alt rear.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
