|
Tractor Talk Discussion Board |
Re: Re: built a loader frame, now how to measure for the cylinders?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Green on February 26, 2001 at 04:19:10 from (209.130.130.226):
In Reply to: Re: built a loader frame, now how to measure for the cylinders? posted by Catless on February 26, 2001 at 03:06:10:
Yes Catless , My cylinders are 2" longer. That seems to be just about right. Acually , When I put mine on , I determaned the positioning of the cylinders by letting the loader arms touch the ground , and then attaching the cylinders. Then when putting the blade , etc. on the arms , that will give the extra 2" needed for down preasure.
Follow Ups:
Home
| Forums
Today's Featured Article -
Using Your Tractor: Creating a Seed Bed - by Chris Pratt. When I bought my first old tractor, I had only one idea in mind. It wasn't the preservation of old iron since at that time, I was unaware that people even did this. It wasn't to show off my restoration skills (though I had tried my hand at a couple of old motorcycles in my teens and if I recall correctly, those old motorcycles were sold in boxes about one quarter finished). It wasn't to relive memories of Grampa, Dad or myself out on the back 40 nursing the Farmall pulling too many b
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
