I farm, used to do construction work, and bought and sold a few hundred loaders the last few years so I think I have a clue. Bottom line is buy what you want
Forget the CAT, several a week show up on insurance sites that have caught fire, maybe one every other month of other brands. Cat loaders seem to have high issues of hydrostat, hydraulic, and wiring issues. I wouldn't be scared of the engine
Case loaders are decent, not perfect, pretty old design but works, I think they have higher than normal hydrostat failures. Cycle times on the case loaders seem slower on the older machines
Deere skidloaders are getting to be decent machines, stay away from the 200 series 1, series 2 are better, 300 series are mechinically good, but a pain to get in and out of and can't see out the sides the best when the boom arms are down. Deeres probably have the most engine power for the size of loader
New Hollands are not bad machines either, not overpowered, fairly reliable machines. Dated design. Hydraulics have issues with lower hours than most. I have tore into them, aluminum pumps and cheaper versions of valves are a lot of it. Engines are just OK, nothing to write home about and are not the best cold weather starters (20 and under)
Bobcat loaders are good machines. In years past, they account for about 47-48% of all machines sold new, I think that says something. I bought a new 205 in 08 and haven't had one single issue with it except the block heater quit working and they replaced it for no charge at all. I am not sure about the new 'm' series yet
I think the bobcat would stand out, but that is what I bought, buy what you want
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.