Tractor Talk Discussion Board |
Re: Fire! through carb
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dirttracker on March 04, 2001 at 16:44:19 from (192.206.56.1):
In Reply to: Fire! through carb posted by HowlongcanmynamebeIwonder on March 04, 2001 at 01:41:55:
Have you replaced the spark plugs? Old spark plugs get high resistance which makes them hard to fire which will sometimes cause cross fire in the distributor to a cylinder next to the one thats supposed to fire, that intake valve is still open and there isn't any compression in that cylinder yet which lets that spark plug fire easier than the plug thats supposed to fire which is under compression. Bad plug wires can cross fire, but normally a carbon tracked cap or dirty cap will cause your problem. If the cam gear has shelled the plastic teeth off and jumped timing that will cause the same problem, but when you get is started you can normally tell be the sound of the engine that the timing is off, also it will jump far enough off in a short time that it wont run at all and sound as though all the plugs are removed from the engine and it will blow gas and air out of the carb when you crank the engine. Have fun.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|