Posted by Billy NY on January 19, 2010 at 09:46:34 from (74.67.3.238):
In Reply to: tire chains posted by dave2 on January 19, 2010 at 03:07:50:
Rich has a good point there, if the conditions you describe were not as so, you can indeed churn your tires right in but good. Oftentimes, that extra bite is beneficial when there is good ground under you, just the top being a problem, frost keeping it from draining etc.
Other times, you may be able to pass a wet area 1x or 2x, then the water pumps up and you'll lose flotation, sink, get stuck or deal with miserable ruts, can't tell you how many times I've experienced that with a backhoe, good thing is you can use the hoe and or the front bucket to get out. I've been in 12" deep saturated ruts with my ole ford 850, places where the top soil was saturated from lack of drainage, but there was good ground underneath, little messy but I always get out, sometimes with a little help from the bucket. Other places around here, especially where the old swamp, now a pond, I get too close, forget it, have to call the neighbor and get his 4440 or 3150fwa to get out, 2x I've done that first time I used the D7 caterpillar, since thats been laid up without a clutch, he's my best bet.
Another thing to be wary of is if one side of the tractor is lower than the other, say a side slope or the edge of a field where it meets a marsh or even frozen snow/ice covered ground, those situations always make it much more difficult than the flat areas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
