With the buildings and house being hooked up to a single meter, it means that if you tie in to the house panel box with the generator, you could feed the downed lines to the other buildings...and have possible tragic consequences. Also if you do not disconnect at the meter, when the power is restored, the power crew will probably not know your building's lines are down, and thus they could feed your broken lines and cause disaster. So if it was mine to do, I would pull the master switch (or breaker) at the meter pole, or if there does not seem to be a master switch, then break the seal on the meter and pull it out. It should have 4 large prongs on the back of the glass meter. Some meters pull straight out and some need just a bit of a twist then a pull. With the meter out, when the power company restores power to the main line, your house and buildings will be isolated until you can get an electrician to safely restore your on-site lines.
If you have telephone or cell service, I'd call your power company and find out their recommendations.
Unless you have the proper generator switch wired into your system, I'd only use the generator with extension cords going to whatever appliances you need to power. Do not feed into the house wiring through a dryer, welder, or electric stove cord. This may still backfeed into your downed building lines. Most likely your well pump will need 220 volts to make it run. Maybe you already have a heavy duty 220 extension cord with your arc welder that you could use to feed the well. If so, pull the well's double breaker out of the breaker box and feed it with carefully taped wires from the 220 cord.
As you will probably be powering the generator with a tractor PTO (or maybe its own 25 Hp engine) somewhat near the house, be careful about the wind direction and the engine exhaust. You or family can be just as dead from carbon monoxide poisoning. I surely would not let it run while the family is sleeping!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.