Posted by northeast iowa on January 24, 2010 at 15:55:18 from (206.72.18.143):
In Reply to: Re: Why No Fenders posted by buickanddeere on January 24, 2010 at 14:33:10:
Very simple, there was NO MONEY to pay extra for fenders. To own a tractor was simply a blessing, and the older foks never forgot the lesson that was given to them. Do not spend any more than is totaly necessary to do the job.
That group of folks have pretty much left us to wonder. A old farmer I knew had two WC Allis tractors--only one mag, so he switched the mag after two loads of corn were picked, then he put the mag on the other tractor to unload the two load. That is bad enough, but with a two row mounted picker it seemed almost impossible to me.
He owned several farms, but never spend a dime on something you could do without. He even built a new house (you better believe he needed one) but refused to spend the money for a skill saw. He had a chain saw.
The house didn't look so bad from a mile away. It had a cook wood stove, all wood heat, and a dirt floor in the basment. This was in the late 70's. Why would anyone waste money on indoor plumbing, a lawn mower, or paint. Not one load of gravel was ever hauled in, and cement was out of the question 90% of the time except where the milk cows stood in their stantions.
He did leave all three sons with two farms each. His dad lost the home farm during the depression, so in his mind he did good.
I hope this clears things up a bit as to why I mentioned the depression.
We all know of folks that lived, spending beyond the things they actualy needed, and lost it all--to what extend do things like fenders become something you need?
Does any of your wives question if you need to spend $500.00 on a set of fenders for your old tractor?
He had no fenders on any tractors because it was a waste of money.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.