Yep, I told Dad to change the gear case oil after a few days.
We are actually running it off the 1000 shaft with a 540 adapter. Tractor is running around 1200 RPM or so. Works really well and saves fuel. The 1086 is the smallest reliable tractor we have on the farm, next step down is the 544 gas with only 50 hp and it's not reliable enough to be left unattended. We figure 150 to 175 hours run time on the tractor at this rate should be fine, but of course if the oil looks bad or it starts burning more than usual he will change it out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.