Posted by spacechem on January 24, 2010 at 22:06:07 from (202.103.229.139):
In Reply to: Re: Why No Fenders posted by Jon Hagen on January 24, 2010 at 16:03:41:
I was a freshman in high school, plowing with a JD 70 (of course, no fenders). Along the edge of a field was a tree limb sticking out. Rather than turn out and come in again on the other side, I got the bright idea to stand on the axle housing, hold the steering wheel with my left hand, grab the tree limb with my right, and duck under as I went by (freshman in HS = stupid).
Guess my backside hit the tire, 'cuz next thing I know I'm horizontal and fighting a losing battle to keep my grip on the steering wheel. Lost the battle and looked up at that tractor tire. Then dark, then light again as I prepared to be sliced into 3 pieces 14" wide and buried on the spot.
Then I heard the engine sputtering. Miraculously, my foot had hooked over the left brake pedal and that extra drag was enough to kill the engine. Still had my leg twisted more than half way 'round but at least I was stationary.
In the field alone- no one would come to check on me for a long time, so I flopped around until my foot came loose, pulled the pin on the plow and drove to the house. Longer story shortened, I spent some time in hospital with "only" a small skull fracture.
My dad couldn't believe the tractor had actually run over my head until they went to get the plow and found a nice round hole where I'd been shoved down into the soft bean stubble ground.
If you farm with these things, or if your kids drive or ride on them, GET SOME FENDERS.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.