Posted by Tig on January 29, 2010 at 01:46:17 from (74.36.129.53):
In Reply to: Welding question posted by NCWayne on January 28, 2010 at 23:41:57:
Mig is used for production welding, it is faster and requires little to no clean up. The parts fit well and the blind robot can run a bead where it is programed to. Wire machines have been used on auto bodys for over 40 years. The auto manufactures use then to weld where a spot gut can't weld the required pieces.
I did not see old's post but would agree that stick would be my perfered method also. When you prepare the joint on the machine you don't always get a perfect job (set up). With a stick machine you can see the puddle better and control what you are doing. I have ran a lot of wire but am more comfortable with a stick for heavy stuff.
If you want excellent control in welding use a Tig machine. There are disadvantages with those machines also. There are cheap wire machines and cheap stick machines. You need to have a good machine when doing quality work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.