Posted by bc on January 30, 2010 at 00:36:36 from (71.158.221.179):
In Reply to: OT cable strength posted by Troy L on January 29, 2010 at 11:16:12:
You would have to change all the sheaves to match the new cable including the crown block and not just the traveling block. But more importantly you should look at the drum and see if it is grooved for 5/8" cable. If so, the 1/2" will never lap right and will cross over till it pinches and ruins the cable and maybe somebody's life.
Not sure I'd mess with it and it won't save any money changing out new sheaves and blocks.
I've run a couple cranes and worked in the oilfieds for years drilling on drilling rigs and even ran a cable tool rig once. I've changed and spliced cable and changed winch cables on trucks.
The other part of the equation for grooved or ungrooved drums is that the diameter and and width of the drum is matched to the size of the cable. Even when respooling a drum with new cable, we spend a lot of time with a hammer pounding each wrap in tight. If you don't get the first and each subsequent row tight and with the cable pulled on in the right direction with the right twist, you will never get it to run right on the drum until you end up with a rat's nest and kinked and ruined cable.
For the strength rating of the cables, check the manufacturer. That info is probably on the web somewhere.
With a crane, you have certain safety rules and insurance issues to deal with. You also have to follow the crane mfr recommendations. And it will change all the lift tables and ratings for the crane at each different angle you have the boom set at (an accident waiting to happen for some new operator who doesn't understand all that stuff)
Stick with the 5/8" cable. Or demote that operator to swamper and let him work under that crane.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.