Posted by dave2 on January 30, 2010 at 12:40:38 from (139.139.35.70):
In Reply to: used atv posted by WA-Hal on January 30, 2010 at 12:28:51:
I've got a chinese model (Jainshe) that is pretty much a Yamaha from a couple years earlier. It's a 250cc 2wd with shaft drive. I pull a harrow on the pasture, have a trailer that I can load 30 bales of hay on or a decent pile of firewood and it pulls it fine. I weigh 250 pounds and can throw 2 bales of hay on back and one on frt for quick feeding trips. Can pile on plenty of junk along with the dog and zoom right along. Plenty of power, but 4x4 would be nice every now and then. I think with 4x4, you should go to a 400cc.
My $.02.
You can buy a new Jainsche for about what you'd pay for a used Yamaha..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
