Tractor Talk Discussion Board |
how 2 repair a cast aluminum hole the size of a quarter?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by tom on March 24, 2001 at 12:03:16 from (206.243.130.85):
I am restoring a 1940 Cast Alumiunm Ford 9N Dash... I do not want to paint the dash section but polish it. And of course, there is a cobbed hole about the size and larger of a quarter just left of the ammeter gauge that does not belong for that year and model of dash. It was hand drilled, the perimter looks as if a chisel was used to enlarge it, and a small diameter round file was then used to enlarge the interior of it. It's not a very good hole to say the least. Can it be filled? and then ground and polished to match the surrounding dash? and/or will there be a noticeable patch? What is the recommended technique, process and material to best fill it? Other options? thank you in advance. tom
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|