Would it be possible for all the dirt and stuff that floats around an old barn to get into the plug and light switch enclosures, with all the wet weather we have, and cause a small amount of voltage draw across the hot and ground wire? Just a thought. I do have a ground rod at the base of the breaker box that goes up to the ground buss with a #8 or so copper wire. The waterier is about 25 yards from this point. The heating element appears to be good, as it works with the bare ground wire loose without any stray voltage in the water. The voltage is coming back from the barn? Would it hurt to leave the bare copper ground unhooked and drive a ground rod at the water and ground that way? I know I still have a problem to fix but the cattle would have water that would not shock them. If I have a bad ground at the ground rod would this cause this? The power comes to the meter pole were it splits and goes to the house and to the barn, the main ground wire goes into the ground at the base of the pole, I guess as deep as the pole is set. When it gets to the barn it drops into the breaker box and out to about 6 circuits with a ground rod at the barn. All that is in the barn is lights and ele. plugs with nothing plugged in at this time. What if any kind of voltage should I see, would be normal on this wire. Thanks for every ones help on this, kind of a strange deal for me?????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
