Posted by Leroy on February 04, 2010 at 06:28:16 from (209.143.52.189):
In Reply to: Wards Grainbuster posted by ryanwheelock on February 04, 2010 at 05:50:13:
The MA-15 mill is a 15" mill sold by Wards in the mid fifties. 1956 catalog information. Grinds up to 9,000 lbs. of ear corn per hour through a 1-in. screen.Feed opening, 15. 476-sq.in. screen area. 32 hammers, 1/4" thick. Size overall: 48in. high, 40 5/8" wide, 64" long4" diameter by 7 3/4" face pulley, 1 3/8" bore. Operates on 2 plow tractor and up.Recommended speed of Rotar is 2400 RPM under load. Shipped with 1/8" screen unless other size is specified. weight with dust collector and bagger 587 pounds. cost was $194.50. Screenes of 1/16, 3/32, 1/8, 3/16, 1/4, 3.8, 1/2, 5/8, 3/4. 1, 1 1/4, 1 1/2, 1 3/4" avaible. The feed came out the blower to the dist collector that was above the mill and dropped the feed either into a wagon loading schute or bagger, the small opening at the bottom is for the blower to be able to get enough air to work. And they will handle all grains and hay. Your tractor has a larger pully and mill a smaller pully so that speeds up the rotor. Questions, later
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
