I guess that it depends on your local building code. Years ago I sold two houses at about the same time. One in Indiana where I plumbed the whole thing with copper, sweating all of the joints. No problem with inspection when selling it. The other I sold in Illinois where apparently the local code didn't go for pressure couplings. I sweated most of it, but were a couple of places where because of the fit, and not being as slim as I used to be as well, I used pressure couplings which I've done before, never ever had a problem leaking. This time though was different. When the inspector saw that, he told me they had to go. I was surprised to hear that, but he wasn't going to pass it until they went away. I guess where there's a will, there's a way, because I sweated in new pieces that as I recall almost required me standing on my head and hanging like a bat to get to, because again, I was to chubby to get into from the side. Bottom line, I guess that local building code might dictate, especially if you ever go to sell.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
