Posted by Joe in Neb on February 09, 2010 at 12:13:03 from (207.5.116.146):
In Reply to: shop heat posted by Rick Kr on February 09, 2010 at 09:24:03:
I have had about all different kinds of heat in shops. With wood you tend to huddle around the stove and freeze on edges of building. Gas or oil furnaces heat the air but when you open the door its all gone and takes probably half hour to hour to get toasty again. Radiant tube heat is by far the best hands down! I Didn't think price was so high on it. I heat a 50 by 90 by 18 with one 180000 tube and keep building at 58 at night and 62 during day. Will warm up to 68 in about a hour. Cost for radiant was around 1500 and cost to operate is around a 1000 for winter. Thats for 800 gals of propane. To heat with regular furnace in old shop 24 x 40 x 10 cost about 800 for about 600 or so gals of propane. I wouldn't even consider any other source for shop if you are planning on heating full time and or working in it very much.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
