Posted by northeast iowa on February 11, 2010 at 06:12:31 from (206.72.18.89):
In Reply to: V Snowblowers posted by nw_bearcat on February 10, 2010 at 20:53:32:
It is like everything else, ya have to know how to run it. I have one on the back of a WD Allis, and it works great. I have a different one with a straight auger on another WD. The ARPS is a cheap way to go if a budget is a issue. Every farmer will tell you they do not work, so I'm always looking for those kind of deals.
They do not work for drifts over three ft. if you intend on a one pass ordeal.
The trick is to raise the blower off the surface a few inches so the snow does not slide. Then make another pass to clean up. So far this winter I have not had to do the second pass, just in real wet snow, so far not the case this winter.
I have a loader with a snow bucket on the front so the 1/2 inch snow, I push into a windrow, then blow it.
I can't imagine anyone blowing with any blower with out live power.
My other blower only comes out in real deep, three ft storms.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
