i like the 10-si delco simple, cheap and reliable.the problem on H & M is mounting it so the belt and hood will work, unless you use a smaller diameter than the delco. if you don't won't to go to all that, you can replace your 6 volt reg. with a 12 volt reg. your generator can produce approx.17 volts more than enough to work with a 12 volt reg. the gen. will work o.k.with no more load demand than you will have, the gen. doesn't charge until the engine is running about 1/4 throttle or a little better is the drawback, i know of a couple H's and a M set up this way they work fine, you still have to change coil or add a resistor to ign. if it were me i would change the battery to neg. ground switch amp guage wires so it will register right, it may be possible to use pos.grd. with a 12 volt reg. not sure, i don't like pos. grd. myself, never have understood the purpose.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.