|
Tractor Talk Discussion Board |
IH Skid Loader Starts to miss after gets warm
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Peter Kosloski on April 11, 2001 at 08:13:37 from (12.16.65.226):
My IH Skid loader mid 70's with a wisconsin VH4D Engine Starts to miss after it is run for a 5 too 10 minutes. It starts great but then seems like it loads up with gas or is starving after a short run. It will start back up ok after a stall but will not take the throttle increase without stalling. I have changed plugs, Confirmed wires spark and conections are good, looked at points, cap and rotor and cleaned. Now I am onto the carb and I took off the fuel line at the carb and the fuel just runs out and never stops. I was wondering if this is normal for I am on the output side of the fuel pump and seems to just run through it. Is this a sign of a bad diaphram or check valve in the pump. Any help is appreciated I am gettin frustrated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
