Tractor Talk Discussion Board |
Re: what kind of building do you recomend
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on April 11, 2001 at 09:28:38 from (38.192.251.39):
In Reply to: what kind of building do you recomend posted by Duane on April 10, 2001 at 19:52:09:
Duane - I put up a straight wall steel bldg. from Millennium Steel with full fiber and rebar reinforced concrete slab (~14K bldg & slab only). Walls are 24ga & roof is 26ga. Screwed up & did not add insulation - so far no issue but told it will be in the future. Bldg is 30w x 50L x 14h enclosed, adding a 10' covered extension of the rear for fuel storage. Later this summer/fall planning to add a lean to of the east side for parking my equipment on dirt floor. I looked at pole bldgs. & cost was nearly the same as steel. Less maintenance in FL with steel. I did not like Quanset style due to lost storage space because of the wall construction - ridges. Also lost storage due the arch vs. straight walls. The ridges were throughout the entire structure, and I thought it would be a hassel when wiring, plumbing, adding work benchs etc. Check out the link below for some free PDF plans. HTH, ShepFL
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|