Posted by CRUSADER on February 22, 2010 at 07:47:45 from (74.211.79.38):
In Reply to: Sleeves Vs. Honing posted by J Heitkemper on February 22, 2010 at 03:57:04:
If the cylinder walls are mic'd and are within tolerable limits...by all means hone the cylinders and install new rings. You will get a few more years/miles/hours out of it. And, if your on the tight budget as to what you can and cannont invest in the equipment and a valve job and/or head rebuild doesn't fit into said budget...by all means, "lap" the valves in if the seats and the valve faces aren't totaly burned up.
This will not make the engine perform at it's peak ablility but will cure the oil consumption and poor performance for the short term. Lots of times, if the equipment requires repair, but is not used a lot this is a good solution to the problem both timewise and financially.
I agree with the other replies to this thread. I was raised up on and have lived on a tight budget for most of my young life. So many times, replacement costs of equipment and what could be spent on the repairs have driven the short cuts and the patches. I believe that whenever possible to make the performance the optimum is what needs to be done.
Best Of Luck with making your project productive to your needs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.