Tractor Talk Discussion Board |
Re: Concrete floor for pole barn
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Al English on April 11, 2001 at 16:38:03 from (24.30.29.47):
In Reply to: Concrete floor for pole barn posted by Warren on April 11, 2001 at 09:50:47:
Hi Warren, After looking at what other people have done, here's how I ended up doing the floor in my 36x60 pole building: 1. 4" sand base 2. Heavy polyethylene vapor barrier(keeps ground moisture from rusting things in the building) 3. I'm not sure now, but I used either 3"(2+1) or 4"(2+2) foam insulation laid with joints overlapping(get the right kind for use under concrete slabs) 4. 6" slab w/4" wire mesh 5. Sawed joints(narrower and easier to roll over with creeper, floor jack, and small caster wheels) 6. A perimeter rat wall extends below the frost line(most of the time people only go 18" to 24"). 7. The rat wall is poured between the posts/poles. Womanized 5/4 tounge and groove wood is nailed to the outside of the posts/poles and acts as a form for the concrete. The slab is not actually attached to the building, but does surround the posts/poles on three sides. Inside the 12' wide overhead door a section of floor a little wider than the door, and about 25' in, is sloped toward the outside. Otherwise the floor is flat, level, and smooth. With no slope water and spills either must be cleaned up, or squeegied toward the door. If you're using it for a workshop that's fine, if it's more of a barn then an overall slope would be better. Many of the things I did added cost, but you can't go back and add improvements later. If I were building another building for myself I'd find the money and do it the same way. Good luck...Al English
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|