Tractor Talk Discussion Board |
Re: Concrete floor for pole barn
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Franz on April 11, 2001 at 17:34:57 from (209.130.177.215):
In Reply to: Concrete floor for pole barn posted by Warren on April 11, 2001 at 09:50:47:
Just a couple thoughts- I'm in New York, south shore of Lake Ontario, where according to DOT, we have the most freeze/thaw cycles of anyplace in the country. One thing that really helps a lot is a vertical apron of 2" styrofoam buried down to 3 feet. This will stop frost from traveling under your floor from the outside, and keep the barn a lot warmer in winter. In Alaska, they also bury a horizontal apron out from the foundation because frost goes real deep up there. Fiberglass concrete is wonderful, unless you're the guy laying it. Adding Rebar and mesh makes it near perfect, especially if you use a vibrator when pouring to eliminate the air from forming bubbles. Floor masons hate vibrators cause it requires more concrete and labor. Definitely, poly under the concrete, AFTER THOROUGH COMPACTION. Proper compaction means less cracks later. If you are going to run heavy equipment across the floor, put in some bullnoses where the traffic will be. If you'll be running tracked equipment across it, put in some used railroad rail for the tracks to run on. Rails flush with the floor also come in real handy for fabrication and welding, especially if you remember to weld them together before piouring.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|