Posted by kyplowboy on February 25, 2010 at 18:14:38 from (98.93.21.234):
In Reply to: Hi Tensile Wire posted by Reid1650 on February 25, 2010 at 10:51:49:
We have two places to get HT around here, don't know the ga of them but one sells wire that 200,000lb tensile and one sells 175,000lb. They are most of the time about the same price per 4,000' spool. For my money the 175,000 is the only way to go and all I will use. It is much easier to wrap and tye off. It also seems to not want to kink up as bad.
For chargers I have always had gool luck with Gallagher.
20 acres of fence depends on the shape as others have said. You are going to be buy'n in 4,000' spools and most places will take a spool back it the bands have not been cut. To get an idea bum a measure'n wheel or step it off and X4. Add a 100' or so for splices, ties, and corner insulators.
If you have never put up HT before a few words of advise. Start on the back side next to the creek or woods. When you have never done it the first two tries will be ugly. What ever you do never ever even think for a second about take'n the bands off a spool of smooth HT with out have'n it in a spinning jenny. If this is all you are ever going to be doing bum from a neigbor or rent one from where you are getting your wire and other stuff. If you plan on doing more go on a buy you a good one. I have found it works good to have one mounted on a 3' chunk of square 2" tube'n and mount it on the reese hitch of a pick up (or most of the time in my case a trailer made out of truck bed).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
