Tractor Talk Discussion Board |
Re: Why a wheatland tractor for wheat?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don Wadge on April 22, 2001 at 19:30:40 from (216.81.26.165):
In Reply to: Why a wheatland tractor for wheat? posted by Poppinjohnny@aol.com on April 22, 2001 at 11:41:06:
Here in southern Manitoba our farms varied a lot in size in the fifties. We had lots of JD 70, 720, 730, R, 80, 820, 830; McCormick W6,WD9; Case La, 500, 600, 900 etc.; Oliver 88, 99; Minneapolis, Massey; you name it. In the heavy soils of the Red River Valley crawlers were the choice for various reasons; one being that rubber did not wear well in that soil. We didn't have many row crop tractors but there were quite a number of Farmall M's with the wide front. Tractors with narrow fronts were not very practical for grain farmiing and for plowing and pulling discers you ran your right wheels in the furrow which was easier. As far as wide front rowcrops vs wheatland tractors to a large degree no-one ever thought of buying a rowcrop if you didn't need it and actually I think the high-wheel tractors would out-pull a wheatland in the field (not just at tractor pulls). Those who had Farmall M's seemed to pull a little bigger implement than those with W6's. Probably a wheatland tractor would be a little warmer in the field in the late fall. We used to put in some long days after harvest doing the fall work and there weren't too many cabs around until the late fifties.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|