Tractor Talk Discussion Board |
Re: Re: Re: Hydraulic Cylinder
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tyler(WA) on April 27, 2001 at 13:37:28 from (12.13.226.16):
In Reply to: Re: Re: Hydraulic Cylinder posted by Shep ... Cool on April 27, 2001 at 12:57:33:
Unless some manufacturer decided to custom design their own tubes and shafts, they all use standard pipe and shaft sizes. The only parts they actually build themselves are the pistons (to fit standard sized pipe) and the end cap and gland to fit the same pipe and accomodate a standard shaft size. All the seals, 'O' rings and wipers are therefore standard sized. Now that I've said that.... watch your's be something else. That would be certain if I'd made a fool of myself by an arrogant attitude or SHOUTING with all caps. ;-)
Follow Ups:
Home
| Forums
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|